SINGER CLASS 99 User Manual download pdf (Page 25)

Class 99 & 99K

To Adjust the Needle Thread Tension

Lower the presser bar and turn the numbered dial X to bring the numeral "1"

opposite the center line Y, Fig. 29 between the plus and minus signs on the

tension indicator. Press the numbered dial inward as far as it will go, and turn

the thumb nut Z until the pin engages one of the holes in the numbered dial.

Turn the thumb nut, together with the numbered dial, to the left. This should

cause "0" to stop opposite the center line if the tension is properly assembled.

Now insert the pin of the thumb nut Z in different holes of the numbered dial until

one is found which gives a slight perceptible tension on No. 50 mercerised

thread when the thumb nut is turned to the extreme left and the numeral "0" is

opposite the center line. This tension gradually increases with the turn of the

thumb nut to the right, providing a full range of tensions from light to heavy with

one revolution of the thumb nut.

Fig. 29 To Regulate Needle Thread Tension

To Adjust the Tension on the Thread Take-up Spring

The tension on the thread take-up spring should be just sufficient to take up the

slack of the needle thread until the eye of the needle in its descent reaches the

material.

To Adjust the Bobbin Thread Tension

First adjust the needle thread tension, as instructed above. Then, using No. 50

mercerised thread in both the needle and the bobbin, and using two thicknesses

of thin material under the presser foot, turn the numbered dial by means of the

thumb nut, to bring the numeral "4" opposite the center

Page 25

Table of Contents | Previous Page | Next Page

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

No comments

SINGER CLASS 99 User Manual Page 25