Form K2INSTRUCTIONS FOR USINGSINGER 12K“FAMILY”SEWING MACHINEUnder View of MachineThe figures shown in the above illustrations are the numbers of the
10THE quilting guide.Attach the guide by passing the horse-shoe shaped clamp over the presser bar from behind, bringing the holes in
11THE TUCK-MARKER.Attach the marker to the machine by the thumb screw, passing the needle through the eye in the tongue upon the mark
12RELATIVE SIZES OF NEEDLES AND THREADS(Class and Variety of Needles used 12x1)Sizes of NeedlesCL.A.SS OF WORK TO SEW ,J.inen or Silk()Very thin Si
BALANCE WHEEL STOP MOTION.This device allows the balance wheel to run free, so that bobbins may be wound and the correct method of treadling
at the same time allowing the feet to move freely and lightly with the motion of the treadle. Continue to do this until a regul
Having removed the bobbin from the spool winder, take it between the thumb and finger of the right hand, being careful that the t
Test the tension of the shuttle thread by drawing it towards the round end of the shuttle. If it draws as tightly as it will b
The preceding Instructions are full and complete for the'perfect use of the Machine.A few special notes are added below in explan
ATTACHMENTSTHE ADJUSTABLE BINDER.Adjust the binder to the desired width of binding and fix it firml5^ to the machine with the thumb screw. Plac
8THE CORDER.é,Attach the corder foot to the presser bar, pass the cord into the eye of the guide, which is held in the left hand
9Each embroidering thread should pass under the tension spring, so that it is lightly held between the spring and the lever to give a very
Comments to this Manuals