Singer 9113 User Manual download pdf (Page 12)

REPLACING PRESSER FOOT WITH SHANK

Presser feet with built-in shanks can be replaced as follows:

Turn machine off.

Raise needle and presser foot.

Loosen presser foot screw (1) and

remove presser foot with shank (2),

guiding it toward you and to the right.

To replace presser foot with shank,

hook shank around the presser bar

and tighten,presser foot screw.

ATTACHING DARNING AND EMBROIDERY FOOT (G)

(Not included on 10 stitch sewing machine. See page 35).

This foot permits better control of fabric when doing free motion work.

• Raise needle.

Remove presser foot with shank.

Guide Darning and Embroidery Foot

from back of needle, with holding fork (1)

around presser foot screw, and lifting

finger (2) above needle clamp.

Tighten presser foot screw with coin.

To remove, loosen screw; guide foot

back.

ATTACHING FEED COVER (F)

The feed cover keeps the feed from moving the fabric.

Raise needle and presser foot.

Open slide plate.

Slide feed cover on top of needle plate,

pressing tabs (1) and (2) into holes.

Close slide plate.

To remove, open slide plate and lift

front edge of cover; pull it away.

1 ... 11 12 13 ... 40

No comments

Singer 9113 User Manual Page 12