Singer 610U User Manual download pdf (Page 8)

^ :

TO CHANGE THE NEEDLE

1. Raise needle bar to highest position by turning hand

wheel toward you.

2. Loosen the needle-clamp screw and remove the

needle.

3. Insert new needle in clamp, with the flat side of

the needle to the back and the long gfsova toward

you; push it up as far as it will go.

4. Tighten needle-clamp screw.

This machine uses needles

Catalog 2020 (15X 1)

Sizes 9, n, 14, 16 and 18.

TO HOLD SPOOLS ON HORBZONTAL SPOOL PIN

Remove spool holder A

from spindle by sliding

in to the left.

Slip spool

onto spindle.

of thread

To hold small spools—

Turn small end of spool

holder to the right and

slide onto spindle. Press

spool holder firmly against

spool.

To hold large spools—

Turn wide end of spool

holder to the right and

slide onto spindle. Press

spool holder firmly against

spool.

SMALL SPOOL HOLDER

A small size spool holder S is furnished with the

machine. This spool holder lets thread unwind smoothly

when very small spools wound with embroidery thread,

etc. are retained on the spool pin.

VERTICAL SPOOL

This spool pin is used when two-needle stitching is

desired. For instructions, see page 22,

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 42 43

No comments

Singer 610U User Manual Page 8