Singer W616 User Manual download pdf (Page 47)

4H

FOR PORTABLE INSTALLATION

Pleciso recid ihese important instructions which

were written to oid you in placing your new

sewing machine on its portable bose.

First, remove the nail which holds the foot

control msicJo the base to avoid damage in ship

ping. If a small plastic clump is fastened

to the back and not to the top of the partition

at one end of the base, remove it, too.

After unpacking the sewing machine unit,

being certain to take out the instruction book,

guarantee and accessory box, lay the unit face

down on a table. You will see two clamping

screws A entering head hinge holes B on the

underside of the back.

On the base you will find two head hinges

C which will fit into holes B. Lower the base

onto the sewing machine fitting hinges C into

holes B. Tighten screws A securely with a

screw driver.

With machine in sewing position attach plas

tic clamp D to top of partition with screw pr

ovided so that it may be turned across the bed

of the machine, to hold it down. (On some

bases the clamp may be positioned in the pro

per spot).

To make the electrical connection draw the

two wires through the slot in the partition of

the base. plug the cord labeled "Motor” into

the receptacle marked "Motor" on the block

attached to the outer section of the base. Then

insert the other cord into the "Light" receptacle.

Place the foot control on the floor, insert

plug into a wall outlet (110-115 volts) and you

are ready to sew. But first read the instruction

book to become familiar with the threading of

the machine, tension adjustments and all the

other features designed to make sewing a ple

asure.

1 2 ... 42 43 44 45 46 47 48

Comments to this Manuals

No comments