[LOO[}C
"IADJUSTING THREAD TENSIONSust right.OVERLOOK STITCHUPPER LOOPER THREAD should lie flat on the top^side of fabric and lock with the lower looper
ADJUSTING STITCH LENGTHTurn the stitch length dial with your left hand until it comes to your required length at the guideline.The hi
...PRESSER FOOTYour machine is equipped with standard presser foot for general use when delivered. Specially designed blind hem f
1. НЕМ STITCHINGMachine trims and overlooks fabric edges simultaneously, to' produce neat, reinforced hem.PIN TUCKSPin tucks are used
...7j^-rriwggam«aa^M>:'~Jo’ntdouble-chain stitchesThe double-chain stitches present appearance like conventional straight
BASIC TECHNIQUESSewing off and back on creates extra threadwhich must be disposed of and tied off.OUTSIDE CORNERSTo attain a neat outside corner, do t
I:INWARD CURVES (Concave)When sewing on inward curve, guide the fabric gently in the way that the seam line is passing through under
4. CARING FOR YOUR MACHINEREPLACEMENT OF MOVING CUTTERShould it become necessary to replace moving cutter, due to it becoming blunt, apply
5. OPTIONAL ACCESSORIESOptional Accessories described in this section are not supplied with this Machine as standard equipments, but can
TABLE OF CONTENTSThis booklet has been written for you, to help you use and enjoy fully your overlooking machine.Before you start to use this machine,
dentification chartLower looper thread____tension dial Upper looper thread tension dial Needle thread tension dialThread guideCover plateRelease lever
;CCESSORY1 parts listed may be obtained from your ¡arest dealer.hen ordering, please give;1. Part number and description.2. The model and
SPOOL HOLDERSFor large diameter cone spools use the rubber spool holders with the large end at the top, and for small diameter ones
Needle clamp screwFITTING THE NEEDLERaise needle bar to its highest point by turning hand wheel towards you, but leave presser foot down.
HREADING LOWER LOOPERPass the thread through lower looper eye, and hook it around part A as indh cated by an arrow on illustration. Leave
HELPFUL HINTSREPLACING THREAD SPOOLSWhen replacing thread spools, the following steps may be helpful for guick changeover.Cut off existing thr
n1J(—DOUBLE-CHAIN STITCHESDouble-chain stitching can be performed either with trimming the fabric or without trimming.Double-chain stitches with
Comments to this Manuals