Singer 301 User Manual download pdf (Page 4)

HANDLE FOR CARRYING MACHINE

To use handle C, turn it up, as shown in Fig.

3, When not in use, turn handle down.

CAUTION: When you have finished your

sewing, always disconnect plug from electrical

outlet.

TO REPLACE MACHINE IN CABINET

Disconnect both terminal plugs. Grasping han

dle C, Fig. 3, place machine in cabinet so

that holes MM, Fig. 3A, fit over studs NN in

machine cradle. Press down on left end of ma

chine until latch

FF, Fig. 2, snaps into posi

tion to hold machine in place. Tilt back ma-

Fig. 3. Showing Handle for Carrying Machine

chine with cradle, install controller in side of

cabinet as shown in Fig. 3B, then connect

2-pin terminal. Lower machine to sewing posi

tion and connect 3-pin terminal.

Fig. 3A.To Replace Machine in Cabinet

Fig. SB. Replacing Controller in Cabinet

LIGHT

The Light is turned, “on” or “off” by the

switch F, Fig. 4.

To Remove Bulb. Remove two screws D and

lamp cover E. Do not attempt to unscrew bulb.

Press it into socket and at same time turn bulb

over in direction shown in Fig. 4B to unlock

bulb pin G, then withdraw bulb.

To Replace Bulb. Press new bulb into socket

with bulb pin G, Fig. 4A entering slo jf

socket and turn it over in direction show in

Fig. 4B to lock bulb pin G in position. Replace

lamp cover E and securely fasten it in position

with two screws D.

Fig. 4. Replacing the Bulb

Fig. 4B.

1 2 3 4 5 ... 36

Comments to this Manuals

Kathi 25 May 2024 | 03:05:31

I have a 1956 singer and don’t know how to make the bobbin attach to needle