Singer 301 User Manual download pdf (Page 6)

UP1»ER THREADING

See Figs. 6 and 7

Raise take-up lever 8 to its highest point.

Place spool of thread on spool pin 1

Lead thread into thread guide 2

Into thread guide 3

Down into thread guide 4

Down, under and from right to left between tension discs 5

Hold spool tightly and pull thread up against take-up spring

7 until it enters retaining fork 6

Pass thread up into thread guide 4

From right to left through hole in take-up lever 8

Down through eyelet 9

Into wire thread guide 10

Into wire thread guide 11

Into guide 12 on needle clamp

From right to left through eye of needle 13.

Draw about two inches of thread through eye of needle.

Fig. 8. Removing the Bobbin Case

TO REMOVE THE BOBBIN

Raise needle to its highest point.

Raise bed extension J. Grasp bobbin case latch

K and lift out bobbin case. Release latch and

remove bobbin.

TO WIND THE BOBBIN

See Fig. 9 on the following page

To stop motion of needle, hold hand wheel L

and loosen knurled screw M by turning it over

toward you. Lift bobbin winder out of recess

and bring its pulley N into contact with hub of

hand wheel.

Place bobbin on bobbin winder spindle as far

as it will go.

Place spool of thread on spool pin 1.

Draw thread under and between tension discs

Pass thread through one of the holes in left

side of bobbin 3, from the inside.

Hold end of thread as shown in Fig. 9 and

press controller pedal as for sewing. End of

thread must be held until it is broken off.

1 2 3 4 5 6 7 ... 36

Kathi 25 May 2024 | 03:05:31

I have a 1956 singer and don’t know how to make the bobbin attach to needle

Singer 301 User Manual Page 6