Singer 9618 User Manual download pdf (Page 11)

tb

la

CHANGING PRESSER FEET

Snap-on Presser Feet

The presser feet furnished with your machine

snap on and off a common shank.

Raise needle to highest position by turning the

hand wheel toward you. Raise presser foot.

To Remove and Replace Foot

1 a. Press toe of presser foot upward as far as

it will go.

1 b. Then snap down to remove.

2. Centre the new presser foot under the

shank A and lower the presser foot lifter so

that the shank fits the presser foot pin.

3. Press presser foot screw down firmly until

foot snaps Into place.

CHANGING THE NEEDLE

• Raise needle to its highest point by turning

the hand wheel toward you. Loosen needle

clamp screw B and remove the needle.

• Insert new needle up into clamp C as far as

it will go. with the flat side of the needle to

the back.

• Tighten needle clamp screw.

ATTACHING BLINDSTITCH

HEM GUIDE

• Raise presser foot, loosen presser foot

screw with a coin and slip blindstitch hem

guide between screw and shank of the

general purpose foot.

• Be sure underside of the guide clears the

slide plate and front of foot.

• Tighten screw with a coin.

1 ... 10 11 12 ... 74

Comments to this Manuals

No comments