Singer M100A User Manual download pdf (Page 11)

THE IMPROVED FAMILY SINGER.

flanges of the bobbin until it catches, to bring the pulley in contact with

the driving-belt

To wind the bobbin, place the spool of thread on the spool-pin at

the base of the arm. draw to the right between the retainer discs, pass the

end about an inch through the slot in the outer end of the bobbin from the

inside (this must be done before the bobbin is placed on the spindle) and

“Operate the Treadle " the same as in sewing until the bobbin is filled,

when it will stop automatically.

The free end of the thread must be held with the hand until a few

coils are wound, and should then be broken off.

To Remove the Bobbin.

Tto. 9.

Open the slide on the

beil of the machine, and

bring the shuttle into

position by turning the

balance-wheel toward

you until the needle-bar

reaches its lowest ¡joint;

then with your left hand

under the table, remove

the bobbin, by ¡>lacing

your thumb against the

cap, on outside of the

shuttle (as shown in Fig.

9) and press it outward

as far as it will go; the

cap will then remain

o|Jen and allow the bob

bin to drop out into

your hand.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

Singer M100A User Manual Page 11