HOW TO CONNECT THE MACHINE TO THE POWER SUPPLY1. Fit the machine plug into the machine.2. Plug the machine to the power supply.Note:‘Before pluggin
THREAD AND NEEDLE CHARTFABRICSTHREADSNEEDLE SIZELIGHTWEIGHTCrepe de Chine, VoileLawn, Organdy, Georgette, TricotFine Silk Fine Cotton Fine SyntheticFi
CHANGING THE NEEDLE1. Turn the balance wheel towards you until the needle is at is highest position.2. Loosen the needle clamp screw
1. By raising or lowering the presser foot lifter, the presser foot goes up and down respectively.2. For additional clearance, the foot lifter can b
To Remove: .1 Turn the balance wheel towards you until the needle is at its highest position. Raise the presser foot by lifting the presser foot lif
It is not necessary to remove the foot holder unless you use blind stitch hem guide or to allow clearance when you clean the feed dog.
regulating the thread tensionGenerally thread tension should be controlled by the thread tension dial. Bobbin thread tension has teen a
STITCH LENGTH DIAL REVERSING BUTTON AND DROPPING THE FEEDTo change the length of the stitches proceed as follows:Turn the dial so that the numbe
THE PATTERN SELECTORThe desired pattern can be selected by turning the pattern selector dial. The marks on the dial correspond to the. 1 .-.I,.patte
IMPORIANT SAFETY INSTRUCTIONSWhen using an electrical sewing machine, basic safety precautions should always be followed, including the
5 Never drop or insert any object into any opening.6. Do not use outdoors.7. Do not operate where aerosol [spray] products are being used or where
DO'S AND DONTS1. Always be aware of the up-and-down movement of the needle and do not turn your attention from the machine while it is running.2
KNOWING YOUR SEWING MACHINENames of parts...4-5How to connect the machine tothe pow
Sewing buttonholes...26-27Sewing zippers...
1. Pressure regulator (Patch^O^Matic)14. Switch2. Thread guide15. Thread tension dial3. Thread take-up lever16. Needle bar4. Bobbin winder thread guid
Comments to this Manuals