Using the machine
Inserting needles
- Switch the machine off “O”.
Disconnect machine from
electricity supply.
- Turn the handwheel until needles
are fully raised.
- Lower the presser foot.
- Use the hexagon wrench to
loosen the needle setscrew.
Remove needle.
- Insed the needle flat side
towards the back, as far as
possible into the needle clamp.
Tighten the screw.
- The left needle is set higher than
the right needle.
n n
t
A
y
Raising the upper knife
- Turn the handwheel to raise the
needles.
- Open the looper cover.
- Press the upper knife holder to
the right. Turn the knob
clockwise until the knife engages.
- Close the looper cover.
To lower the upper knife;
- Turn the knob anti-clockwise.
The knife snaps automatically
into its lower position. Clo5e the
looper cover.
15
Comments to this Manuals