INSERTING A WOUND BOBBIN
When you want to sew with a bobbin that is already wound, insert it following the
instructions below.
• Raise presser foot.
• Turn hand wheel toward you until
needle is in its highest position.
a Open slide plate completely, and
remove bobbin.
1. Pull 4" (10cm) of thread from replace
ment bobbin and insert bobbin, with
rings facing up, into case.
2. Holding bobbin in place, guide thread
into notch (1).
3. Bring thread around and past point #2.
4. Holding bobbin thread on outside, leave
slide plate open.
• Follow directions for “Raising Bobbin
Thread”, on page 18.
17
Comments to this Manuals