Singer 7050 User Manual download pdf (Page 40)

Mli

WIDTH

Pull buttonhole lever (8), located under

sewing light, straight down as far as it

will go.

Press it toward you.

Start running the machine.

The entire buttonhole will be stitched

in one operation.

Stop sewing when machine begins over

lapping starting stitches.

Raise foot lifter and remove work from

machine; clip thread ends; cut button

hole opening with scissors or seam

ripper.

(Adjust width and balance of test

buttonhole, if necessary.)

Press buttonhole lever toward you for

each buttonhole to be sewn.

When all buttonholes are completed,

push buttonhole lever (8) back up into

machine.

To remove buttonhole attachment, raise

presser foot lifter and press down on

both sides of button carrier near shank,

and slide off machine.

ADJUSTING WIDTH OF

BUTTONHOLE OPENING

If the width of the buttonhole opening is

too narrow or too wide, it can be adjusted

by the stitch width lever.

• Widen the buttonhole opening by mov

ing the stitch width lever slightly left.

• Narrow the buttonhole opening by mov

ing the stitch width lever slightly right.

ADJUSTING BALANCE OF

BUTTONHOLE

If the two stitching sides of your button

hole are unequal, turn stitch balance ring

(9) behind pattern selector dial.

• If the right side of stitching is too open

(10), turn stitch balance ring slightly left.

• If the left side of stitching is too open

(11), turn stitch balance ring slightly

right.

38

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 50 51

Comments to this Manuals

No comments