SINGER SEQS-6000 Instruction Manual download pdf (Page 34)

ATTACHING EMBROIDERY UNIT

1. Turn off the machine.

Turn connector cap to the right to open.

2. Slide the embroidery unit onto machine tting connectors

on the machine and embroidery unit. Slide the embroidery

unit as far as it will go until it clicks into place.

3. To make sure that the embroidery unit is fully engaged,

hold the handle of the embroidery unit and pull it towards

the left direction, checking that the embroidery unit does

not detach.

Note:

If embroidery unit is not securely installed, the finished

embroidery may be distorted. Make sure that the

embroidery unit is pushed in as far as it will go.

CAUTION

Always be sure to turn off power to machine

before installing embroidery unit.

REMOVING EMBROIDERY UNIT

* Turn off the machine.

* Remove embroidery hoop from machine.

(Refer to page 36.)

1. Holding handle of embroidery unit, carefully slide toward

the left while pressing release lever.

Note:

Do not pull carriage when removing embroidery unit.

2. Turn the connector cap to the left to close for general

sewing.

CAUTION

Don’t push the carriage or put strong pressure

on the embroidery unit while attaching or during

the embroidering process. Doing so may cause

damage to the embroidery unit.

Connector cap

Connector

Carriage

Release lever

Handle

Release lever

Handle

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

No comments

SINGER SEQS-6000 Instruction Manual Page 34