Singer 1030 Creative Touch User Manual download pdf (Page 43)

Procedure

• Place the button you intend to use on the

button carrier of the one-step buttonhole

foot and slide clamp toward back to secure

button. For use without a button, set the

clamp with the gauge lines on the carrier.

See page 39.

• Draw needle and bobbin threads under foot

to back of machine.

• Place garment between foot and underplate.

Align buttonhoie guideline markings with

the red guidelines on the foot. Lower foot.

• Press buttonhole lever toward you.

• Start machine and let it stitch the entire but

tonhole. Maintain an even sewing speed

(and use the same rate of speed for each

buttonhole you sew).

• Stop machine when stitching starts to over

lap the starting bar tack. Move stitch-width

dial to setting and take one or two

fastening stitches.

• Remove work from machine, ciip thread

ends, and cut button opening. For additional

information on the cutting of button open

ings, refer to page 40. If necessary, reset

stitch-width diai on red | for next but

tonhole.

When buttonholes are completed, push but

tonhole lever up into machine and reset dials

for regular sewing. To remove buttonhole foot,

press down on the button carrier on both sides

of the presser foot shank.

Turn to page 38 for information about adjusting

test buttonhole.

37

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 76 77

Comments to this Manuals

No comments