SINGER Stylist II Instruction Manual download pdf (Page 17)

CUTTING WIDTH GAUGE

Use the cutting width gauge to assure the fabric is cut and sewn consistently. Adjust the width

gauge for the desired seam allowance.

THREAD CUTTER

Thread cutter is built in needle plate. Trim thread near the end of fabric by pushing down the lever

as illustrated.

CHANGING PRESSER FEET

Be sure needle is in the up position. Raise presser foot lever.

1. Push foot release lever to remove the foot.

2. Place the desired foot on the needle plate aligning needle holes.

3. Lower the presser foot lever and push foot release lever so that the foot holder snaps on the

foot.

III

CHANGING NEEDLE

Raise needle bar to its highest point by turning hand wheel towards you, but leave presser foot

down. Loosen needle clamp screw to remove the needle, and place new needle with at side away

from you, into the needle bar as far as it will go, and tighten screw.

Illustration *

: Foot release lever

: Needle clamp screw

III

: Flat side away from you.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 66 67

No comments

SINGER Stylist II Instruction Manual Page 17