SINGER Stylist II Instruction Manual download pdf (Page 51)

BASIC TECHNIQUES

TURNING OUTSIDE CORNERS WITHOUT CUTTING THREADS

1. When you reach the fabric edge, stop stitching with the needle above the fabric.

2. Raise the presser foot and gently pull on the thread chain just enough to clear the stitch nger.

3. Turn the fabric, lower the presser foot and begin stitching in the new direction. Fig. 1.

NOTE: When overlocking and trimming at the same time, cut the fabric along the new

stitching line for about 1.18 inches (3 cm).

TURNING INSIDE CORNER

1. Fold fabric to form a straight line. (1)

2. Fold the upper left corner of the folded portion down to

meet the folder edge. (2)

3. Fold the folded portion again to meet the right edge. (3)

4. Place the fabric under presser foot and sew up to 2

stitches beyond the inside corner. (4)

5. Raise the presser foot and turn the fabric. Unfold the

folded portion and sew the next edge of the fabric. (5)

TURNING CURVED EDGES

Apply pressure at point A in the direction of the arrow with your left hand, and at the same

time apply a little opposite pressure at point B with your right hand (Fig. 3)

For outside curves, place fabric under the presser foot in a similar manner, but applying the

pressure in the opposited directions. Fig. 4

Illustration *

: Cut

1 2 3 4 5

Fig. 1

Fig. 3

Fig. 2

Fig. 4

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 66 67

No comments

SINGER Stylist II Instruction Manual Page 51