SINGER Stylist II Instruction Manual download pdf (Page 37)

THREE-THREAD OVERLOCK WITH ONE NEEDLE

By threading the LEFT needle only, a seam allowance width of 0.24 inches (6 mm) will be

produced. By threading the RIGHT needle only, a seam allowance width of 0.15 inches (3.8mm)

will be produced.

Please remove the unused needle and place it in the needle pad as illustrated.

CONVERTING TO TWO-THREAD USE

To convert to two thread use, rst open the front cover and working table and raise needle to

its highest point by turning hand wheel towards you. Remove the right needle and use the left

needle.

Please remove the unused needle and place it in the needle pad.

Pull out the two-thread converter as showing in Fig. 1.

Attach the two-thread converter onto the upper looper as shown in Figures 2 and 3.

Make sure that you slide the tail end in rst, then put the hook end into the upper looper hole.

When not using the converter, insert it into the storage pad as illustrated in Fig. 4.

Illustration *

: Two-thread converter

: Upper looper

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 66 67

No comments

SINGER Stylist II Instruction Manual Page 37