Singer 518 Stylist User Manual download pdf (Page 10)

ACCESSORIES (Continued)

Changing Presser Foot

Needle Plate

Positioning Pin

CHANGING PRESSER FEET

The presser feet that are supplied with

your machine snap on and off a common

shank. To change the foot:

1. Raise presser foot lifter and turn

handwheel toward you to raise needle

to its highest position.

2. Press toe of presser foot upward (as

far as it will go) and then snap down

to remove the foot.

3. Center the new presser foot under the

shank and lower the presser-foot

lifter so that the shank fits over the

presser-foot pin.

4. Press down on presser-foot screw until

foot snaps into place.

To remove the complete foot (with

shank), as for free-motion darning or

embroidery instructed on page 60,

loosen the presser-foot screw and

remove shank and foot together.

CHANGING NEEDLE PLATES

1. Raise needle to its highest position and

raise the presser-foot lifter (you do not

need to remove the presser foot).

2. Open slide plate with downward finger

pressure. Draw plate toward you,

opening it all the way to raise the

locking pin that holds the needle plate

in place.

3. Place thumb under right side of needle

plate; lift and withdraw plate to the

right.

4. Insert new needle plate under locking

pin and over positioning pin.

5. Close slide plate to lower locking pin

and secure the needle plate.

8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

Comments to this Manuals

No comments