Tension Disc
Pass Thread Through
Hole in Bobbin
• Place thread spool on spool pin over
felt. Lead thread around bobbin winder
tension disc and through small hole in
bobbin (from the inside).
• Place bobbin on holder and turn bobbin
winder switch to WIND.
• Hold thread as shown and start the
machine. Cut off thread end when
winding is well under way.
• When required amount of thread has
been wound (winding will stop by
itself when bobbin is full), stop the
machine and cut connecting thread.
• Turn bobbin winder switch to SEW
and remove bobbin from holder.
•
• Press hand wheel disc for sewing.
Bobbin Winder Switch
Press Here
for Sewing
13
Comments to this Manuals