Singer 7470 CONFIDENCE User Manual download pdf (Page 20)

B. Turn the hand wheel toward you until the needle is in its

highest position and the thread take-up is visible.

C. Thread the machine with your left hand while rmly

gripping the thread with your right hand in the

following order as illustrated.

* Guide the thread through thread guide (1), and

then pull it into the pre-tension guide (2).

* Pull the thread into the tension discs, passing

the thread to the left of plate (2). Then guide the

thread to the bottom of the groove.

* Do a U-turn around the inside of the tab (3).

* Pass the thread through the thread take-up (4)

from right to left.

* Pull the thread into the inside of the take-up lever

until it reaches the eye of the lever.

* Guide the thread into the thread guide (5).

* Pass the thread through the eye of the needle

(6) from front to back. (See following page for

instructions on operation of the Automatic Needle

Threader.)

THREADING THE TOP THREAD

A. Raise the presser foot lifter. Always be sure to raise the

presser foot lifter before threading the top thread. (If the

presser foot lifter is not raised, correct thread tension

cannot be obtained.)

IMPORTANT:

To verify that the machine is threaded

properly in the tension discs, do this

simple check:

1.) With the presser foot raised, pull

the thread towards the back of the

machine. You should detect only

a slight resistance and little or no

deection of the needle.

2.) Now lower the presser foot and again

pull the thread towards the the back

of the machine. This time you should

detect a considerable amount of

resistance and much more deflection

of the needle. If you do not detect the

resistance you have miss-threaded the

machine and need to re-thread it.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 93 94

No comments

Singer 7470 CONFIDENCE User Manual Page 20