Singer SES1000 FUTURA User Manual Page 96

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 95
96
Changing the needle
1. Raise the needle bar to its highest position by turning the
hand wheel toward you.
2.
Loosen the needle clamp screw by turning it toward you.
3. Remove the needle by pulling it downward.
4. Insert the new needle into the needle clamp with the
at
side toward the back.
5.
Push the needle up as far as it can go.
6. Tighten the needle clamp screw firmly with the screw
driver.
Always disconnect the machine from power
supply by removing the plug from the wall-outlet.
* Do not use on stretch fabrics.
* For best sewing results, always use a Singer Branded Needle.
Flat
side
toward
the
back
Flat side
Côté plat
Lado plano
Lado
plano
hacia
fuera
de Vd.
Côté
plat
orienté
vers l’
arrière
Pin
Butée
Pasador
Needle
Aiguille
Aguja
FABRICS THREAD NEEDLES
The fabrics below can be of any
ber: cotton, linen, silk, wool,
synthetic, rayon, blends. They
are listed as examples of weight.
Light-
Weight
Batiste
Chiffon
Crepe
Medium-
Weight
Corduroy
Flannel
Gabardine
Gingham
Linen
Muslin
Wool Crepe
Medium-
Heavy
Bonded Wovens
Canvas
Coating
Denim
Duck
Sailcloth
Knits Bonded Knits
Double Knit
Jersey
Tricot
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 40
* "Heavy Duty"
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 60
Cotton-wrapped
Polyester
100% Polyester
* Mercerized Size 50
Nylon
Cotton-wrapped
Polyester
Polyester
Nylon
2000 or 2020
red
shank
2000 or 2020
red
shank
2000 or 2020
red
shank
2001 or 2045
yellow
shank
11/80
orange
band
14/90
blue
band
16/100
purple
band
18/110
yellow
band
TYPE SIZE
11/80
orange
band
14/90
blue
band
16/100
purple
band
NEEDLE, THREAD AND FABRIC CHART
Your fabric will determine the choice of a needle and thread.
The following table is a practical guide to needle and thread
selection. Always refer to it before a new sewing project.
Generally, the same size and type of thread is used in the
bobbin as in the upper thread.
Page view 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 111 112

Comments to this Manuals

No comments